AEROSOLS

AEROSOL TEST BATH TYPE Z-7505

Aerosol Test Bath is intended to be used for improvement of aerosol products quality and safety rules of its usage by helping to identify a leaking aerosol cans in course of production cycle.

According to accepted standards, testing proceeds by bathing filled and closed aerosol containers in water at 55⁰C for about 3 minutes.

Containers are being transported through a tank filled with hot water by means of driving wheel and a chain with clips for holding the attached containers. Speed of attaching/detaching is smoothly regulated and allows to adapt Test Bath to the capacity of entire line.

Total capacity (assuming that bath will last 3 min) comes to about 60 containers per minute. Test Bath has been also equipped with pneumatic drying system for containers.

Scroll down

Working parameters

Operational parameters

Production capacity:

60 pcs./min.

Containers diameter:

ø35 – ø65 mm (depending on installed grippers)

Containers height:

80 – 320 mm

Valves type handled:

Standard aerosol 1” valve

Duration of test bath:

180 sec.

Water temperature:

55°C

Leakage detection (optional):

Infrared or catalytic gas detectors

Dimensions and mass

Width:

1737 mm

Length:

5131 mm

Height:

1750 mm

Mass:

~1500 kg

Supply

Type of power supply:

Electrical and pneumatic

Electrical supply:

3x400 VAC 50 Hz; 3.55 kW

External control:

24V DC

Air supply pressure:

8 – 10 bar (0.8 – 1.0 MPa)

Air consumption:

Max. 70 m³/h