AEROSOLS

AEROSOL TEST BATH TYPE Z-7505

Aerosol Test Bath is intended to be used for improvement of aerosol products quality and safety rules of its usage by helping to identify a leaking aerosol cans in course of production cycle. According to accepted standards, testing proceeds by bathing filled and closed aerosol containers in water at 55⁰C for about 3 minutes. Containers are being transported through a tank filled with hot water by means of driving wheel and a chain with clips for holding the attached containers. Speed of attaching/detaching is smoothly regulated and allows to adapt Test Bath to the capacity of entire line. Total capacity (assuming that bath will last 3 min) comes to about 60 containers per minute. Test Bath has been also equipped with pneumatic drying system for containers.
Working parameters
Working parameters
Production capacity:
60 pcs./min.
Containers diameter:
ø35 – ø65 mm (depending on installed grippers)
Containers height:
80 – 320 mm
Valves type handled:
Standard aerosol 1” valve
Duration of test bath:
180 sec.
Water temperature:
55°C
Leakage detection (optional – depending on order):
Infrared or catalytic gas detectors
Overall dimensions and weight
Width:
1737 mm
Length:
5131 mm
Height:
1750 mm
Weight:
~1500 kg
Power supply
Type of power supply:
Electrical and pneumatic
Electrical supply:
3x400 VAC 50 Hz; 3.55 kW
External control:
24V DC
Air supply pressure:
8 – 10 bar (0.8 – 1.0 MPa)
Air consumption:
70 m3 /h
Download the product card
pobierz tutaj