• 3
  • 4
  • c1
  • c2
  • c3
Aerosols
Atomizers
Perfumes
Filling lines
Closing Machines
Pharma

Atomizers
Perfumes

Find out more Aerozole
Automatic Machines Automatic Production Lines
close
movie Watch: Movies

Filling lines
Closing Machines

Aerozole
Filling
close
movie Watch: Movies

Pharma

Aerozole
close
movie Watch: Movies

TEST BATH

TYPE: Z-7502

This device allows you to control the tightness of can sealing during the automatic production cycle. Cans filled with product and propellant are water-tested. Proper water temperature (approx. 55 °C) allows the detection of any leaks.

Diameter of supported cans: ø 35÷ ø 66 mm
Height of supported cans: 105 mm ÷ 320 mm
Valve type: aerosol valve with a diameter of 1" without adapter
Capacity: 60 - 250 pcs/min. (depending on the version), i. e. each can is immersed in a water bath for at least 180 sec.
Cans guiding: plastic clips holding the container inside the aerosol valve
Leakage detection: leakage detection: visual – watching bubbles arising or by using infrared sensors
Power type: Electrical and Pneumatic
Supply voltage requirement: 3x400 VAC, 50Hz
Power input: 1kW (without heating system)
Required air pressure: 2 – 8 bar (0.2 – 0.8 MPa)
Air consumption: Max. 75 m3/h (can drying system)
Overall dimensions:
  • Overall length: 5150 mm
  • Overall width: 1460 mm
  • Overall height: 1600 mm
  • Volume: ~2,0 m3

 

Contact

ZIGLER POLSKA Sp. z o.o.
7 Braci Gutmanów st
(entrance at:17 Krakowska st)
43-600 Jaworzno - PL

tel. +48 32 616 36 70
tel. +48 600 248 079
e-mail: zigler@zigler.pl
e-mail: biuro@zigler.pl

www.zigler.pl

All rights reserved
© Zigler 2014